Kreg Owners' Community

I recently had several beech trees cut down from my mountain house and I have a couple of fairly straight peices that I just want to cut down and make pen blanks from what do I have to do to make this stuff stable enough to work with. I know there is enough of wealth of information out here to give me a direction to start with.

Views: 400

Reply to This

Replies to This Discussion

Hi ray how you doing? Best advice I can give you is cut the blanks into 3x3" blocks and that way should dry out quicker ,but you cannot beat a long time on the shelf to dry out timber with a nice airflow .

I've cut them down to blank size immediately. They'll dry in no time and let's face it, most of the blank is waste anyway. :)

Hi hugh will the blanks not twist and bend cutting them to the right size immediately when they dry out ?I have experienced just that with some oak ,go steady mick.

Mick, I'm pretty sure they will. My point is that the majority of the time the twisted and bent blank will still be suitable to make a pen. I've made pens from antlers, which are far from straight.

I take your point hugh ,how easy is antler to work with? Hard to get over here in the u.k.

thanks for your input guy's and I think I will do a little of what you both suggested, I really want a pen from my mountain houses lumber but I also want a blank that I can make a candlestick holder from. What would happen if I put the rough sawn lumber in an oven to dry out. I would tell my wife about itt afterwards of course.

Mick, antler has to be turned very slowly. It is essentially hair, so you can imagine the smell if you let it get hot. Drilling is challenging, as well. I don't really care to work with it, but since I have a LOT of deer-hunting friends...

Ray, I would think you can't set the oven temp. low enough to prevent splitting.

I can imagine the smell hugh ,antler sounds challenging .

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Rip-cut ACS plunge saw

Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue

Started by William Burt Brown in General Woodworking Mar 17.

Is the screw driver impact drill rater?

Is the screw driver impact drill rated?Continue

Started by Bob Naylor in Beginners' Zone Mar 10.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_