Kreg Owners' Community

I recently purchased the Crown Pro jig. In the instructions it mentions to set the mitre saw table depending on if 0 or 90 is in the middle of the table. My saw has 45 in the middle. How do I figure how to set the angle?

Views: 312

Reply to This

Replies to This Discussion

I think they mean to say "when your saw is set to make a square cut to the fence, what is the pointer pointing to?"  There, the answer to the question would be either 0 or 90 degrees.  Most saws will point to 0.

Some saws made by Bosch, Craftsman and Wen (and others) have the pointer and scale offset so directly in front of the saw is the 45 degree mark.  When the saw is set to make a square cut, the pointer will point at 0 degrees.

Tim, thank you for your good advice, Kevin, if you would like any further information, please contact our Technical Support Team directly at 800-447-8638 or technicalsupport@kregtool.com

I made my own jig out of some scrap wood. I apologize for the video not being the best but it will show you the basics of what you need to do.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

First time I really had a need for the ACS miter guide.

I've been using my Adaptive Cutting System table for a few years now, and it's been really solid. This past week was the first time I ever needed to use the miter guide though.I was rebuilding some shelving in a tiny closet and I discovered the…Continue

Tags: ACS

Started by Adam in General Woodworking May 6.

What thread and size screw to use 2 Replies

I am building a small trunk for a military friend to put some belongings in. I have made legs out of ash hardwood and will make the sides out of 1/2” or 3/4” Baltic birch plywood. The legs are 1.5” thick by 2” wide. So since I’m drilling pockets in…Continue

Started by Mike Bohannon in Beginners' Zone. Last reply by Jay Boutwell Apr 19.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2022   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_