I haven't built stairs yet but I have read about it and built a sketchup model for my plans. If anyone could look over it and tell me how it is, it would be appreciated. I'd like to start building soon.
I would be attaching the one brace per side to the house and flashing it, with the siding meeting that piece. I used some quick dimensions in sketchup to know how I'll need to lay those brown pieces out so that they hit the correct angle, I will trim the bottoms to length so they don't get in the way of the outside corner of the siding.
The stringers would then be attached to those.
The house is tan and brown, and the stairs will match.
Yes it is a Duplex.
The house was built in 1905 on a grade, the front of the house is just above ground level
The back of the house, the basement is on ground level.
This is a view of the back of the house.
The middle section on the back of the house was added when plumbing was added, it was built on stilts.
The porches were added later, they were built on stilts.
I jacked up the whole back of the house and built the 2 small additions under each porch, they will be the laundry rooms.
I left the small cubby hole in the middle because the sewer vented there and I also have the hose bibs mounted there, electrical outlets, and a light.
I wanted to minimize the amount that the stairs extended into the patio area since it is a small patio.
Great idea. I rebuilt the outside stairs to my home before I knew about the Kreg Jig, I ran screws into the surface of the stairs and caulked all the screw holes, I pitty the next guy who has to remove them, I hope it won't be me! I think I will be OK for the next 20 years if I keep the paint in good shape. The use of Kreg screws would have made a lot better job. and no caulking.
Recently purchased two 96" tall pantry cabinets that are 23" deep that only came with two adjustable shelves and two fixed, (one at about 55" and one at the very bottom). Shelf holes in the walls are drilled 2" O.C. Like most store-bought…Continue
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…