Kreg Owners' Community

is there a video for the best way to join 3/4" plywood to 3/4" white oak so that i will have a good edge.

Views: 263

Reply to This

Replies to This Discussion

I know this is an old post but I want to reply because I had a big OOPS when I had the local Home Depot pre-cut some expensive birch plywood for a 6 foot tall pantry cabinet. I had 2 96x24 pieces and 4 24x48 pieces. I trued up my table saw and ripped the 2x4's to 16x36 and then drilled pocket holes in one end every 4 inches, applied glue and drilled pocket holes and joined the 2. Life is Good!

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Pneumatic conversion pocket hole 2 Replies

Started by Michael B in Beginners' Zone. Last reply by KregCS 5 hours ago.

Kreg Storage 2 Replies

Started by Jim Mahan in Kreg Jig® Projects. Last reply by R. E. Woods on Friday.

Old Kreg Jig - K1?

Started by Kent Bruner in Kreg Jig® Purchasing Feb 11.

concealed hinge jig stop collar 1 Reply

Started by Joe Grane in Other Kreg® Products. Last reply by KregRep Feb 12.

Kreg Jig K3 defect or not? 5 Replies

Started by Igor in Kreg Jig® Purchasing. Last reply by Randy Hills Feb 13.

Product Reviews

Kreg Foreman

I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.

The…

Continue

Posted by justin waldron on January 8, 2018 at 4:05am — 2 Comments

Kreg K5 Jig Review

Posted by Daris R. on November 20, 2017 at 5:39pm

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_