Kreg Owners' Community

Bench Clamp not working (Came with Mobile project center)

 I received the Mobile project center as an xmas gift and have been trying to use the included bench clamp- but it has issues.  

It wont allow me to close the grip on something around 1.5-2 inches high. Even with two hands I cant clamp anything over .5 inch.  And the screw that goes into the table to glide along I need a wrench to loosen/tighten (along bottom of clamp).

The middle screw that supposedly allows you to adjust auto clamping seems to do nothing.

Please help - Not sure how to rectify situation.   I think the clamp might be faulty.

Views: 361

Reply to This

Replies to This Discussion

1.  Get a box of Wheaties and eat for breakfast.  Just kidding.  Sometimes it seems the clamping tension goes kafooey.  When that happens I try to clamp a different size (even just down to the work surface) then go back to the actual work piece.  Usually that clears up the little hiccup that the clamp has had.  Of course, adjusting the clamping pressure should be done as well - doesn't always take much, just a little turn seems to make a big difference.

2.  As far as turning the bolt on the bottom, it's a common tool but has been factory-installed with Loctite (I think) so may take a little extra effort (more Wheaties).

I tried step 1, it will clamp something that is 1inch thick just not around 2inch. Regarding point 2, even after I first loosened the screw at bottom, hard to tighten or loosen again without pliers*. Wondering if the threads on screw are faulty.

Please contact our Technical Support team at technicalsupport@kregtool.com or 800-447-8638 - they will be happy to help with this. Thanks!

Are you letting the clamp fully open before clamping a new piece?  Evidently it needs to fully open up to reset the mechanism.

I have the same work bench with clamps, works great. Contact Kreg, good people ready to help

Thanks everyone- and KREGREP.  Very helpful/found resolution.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Adaptive Cutting System/Saw Blade

I have had the ACS for about a year.  Was wondering if there any other blades, like a Diablo, that will fit the saw?Continue

Started by Randall H Gress in Beginners' Zone Feb 20.

AutoMaxx 6" clamp not working

I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset…Continue

Tags: clamp, inch, 6, Automaxx

Started by Anthony M Calabrese in Other Kreg® Products Feb 12.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments

© 2021   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_