Kreg Owners' Community

Hey guys. Long time Kreg Pocket Hole user here.

Looking at switching over to using my 3 3/8" Compact Circular saw with an AccuCut system.

Probably will just use it on a low bench in my shop.

Have a new, smaller shop and my tablesaw does not fit in the shop very well.

Am also in a wheelchair so the tablesaw has always been a challenge.

Love the little compact circ saw as it has a vacumn port and I can get all the dust with the Shop Vac. It is also a little safer than trying to always reach over or around the tablesaw blade.

Has anyone tried the Kreg AccuCut with a 3 3/8" Compact Circular Saw?

Does it fit the adaptor plate?

tx, Ed

Views: 65

Reply to This

Replies to This Discussion

Please contact our team at 800-447-8638 or kregtool.com/help - They will be happy to assist you with this. Thanks!

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Drawer Slide Jig - How to fit bottom drawer?

Hi guys.I'm probably being really stupid here, but I cant see any way to use the drawer slide jig to fit the bottom drawer of a set?I actually have a couple of questions:Firstly, should the drawer slide fit flush with the bottom of the drawer?(That…Continue

Started by Craig in Beginners' Zone on Sunday.

Combination Pocket Hole and Tongue & Groove Joint

All material is 3/4"Tongue & groove is 1/4" tongue into a 1/4" grooveMy thinking is to set the jig and bit as though I was using 1" stock.  Use the screw called out for 3/4" material.  Is my thinking correct.ThanksGeorgeContinue

Started by George in Beginners' Zone Jun 13.

Product Reviews

Kreg Jig Dust Collection Attachment

1st impression when you hold this attachment in your hand:  "not much to it", Kreg sure is makin' $$ here.



Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.



Then the real test, hook…

Continue

Posted by Grampy Meyer on February 23, 2020 at 11:36am

My K4 Master System

I picked up the K4MS from Home Depot about 3 months ago, I was looking for a small filing cabinet for under my desk and nothing I looked at would fit or they wanted big money for it, my wife said “why don’t you just build your own then you will…

Continue

Posted by Randy W. Lush on August 25, 2019 at 12:30pm

© 2020   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_