When I turned 65 my wife and I moved to Corpus Christi and downsized from a large (4,000 sq. ft.) home to a smaller home. The home has a very small kitchen. There are about four appliances (air fryer, waffle maker, crock pot, Kitchen Aid mixer) which we do not have room for in the kitchen and we have to store them in a guest bedroom closet. Since my wife is height-challenged it means they rarely get used. She would like to have a rolling cart on which to store the appliances. I would like to build one for her. I would like to build an open rolling appliance cart with two shelves and a butcher block top. First, does anyone know where I might rustle up a set of plans. Second, if not, what type of joinery would you recommend for the post and shelves?
Thank you.
Tags:
It is difficult to immediately answer you this question.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
Hello - I have a couple of workbenches in my 'shop' and am contemplating putting 2 or 3 pull out bins on the bottom shelves of both. I've not worked with drawer slides before and am looking to make it simple(r). Thinking of making 2 sets of pocket…Continue
Tags: hole, pocket, basket, slide, Drawer
Started by E M Hampton in General Woodworking Jan 10.
My clamp to hold boards to my kreg jig no longer works. It won't move from it's spot and when I push the grey button on top, nothing happens. are there replacement parts for this?Continue
Started by Tammy in Beginners' Zone. Last reply by John Browne Jan 3.
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 2 Comments
1st impression when you hold this attachment in your hand: "not much to it", Kreg sure is makin' $$ here.
Then I installed it.. perfect fit, leaves just enough room to adjust the setting screw on my K4.
Then the real test, hook…
Posted by Grampy Meyer on February 23, 2020 at 11:36am — 2 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service