Hi Kreg community. I just joined and have a question....
I have built my kitchen cabinets...they look great, no problems. Now I want to build a bathroom vanity cabinet that will have two 45 degree angles. Is there a Kreg clamp for that? any suggestions?
Thanks!
Tags:
I would use the square pattern dog holes in my bench with a dog fence ( could use Kreg dogs also ) and Kreg inline clamps. Ratio to get to 45D is 1:1 so say 2 holes across and 2 holes up to place a dog and 5 holes across and 5 holes up to place the other dog. I would try a bar clamp to line the top up first and if that wasn't good enough you could make a clamping block from scrap.
You could also make 2 clamping blocks or Rockler sell an adjustable clamping square which I don't have.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service