Sort by:
Discussions | Replies | Latest Activity |
---|---|---|
K4 for drawersCan I use my K4 for 1/2 in. plywood drawers? Not sure what the Kreg Micro is and if it is necessary to use on 1/2 in. stock. Started by Paul Crow |
2 |
Jun 11, 2014 Reply by Paul Crow |
new Kreg K4MS commentsthis is a great forum and checking out others fine projects is inspiring! I have some comments on my new purchase the K4MS. I have not used… Started by interpon |
2 |
Feb 26, 2011 Reply by Wayne Mclellan |
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
The Clamp anchor screw broke on my mobile project center. How can I acquire a replacement?Continue
Started by Jon J Howard in Beginners' Zone 21 hours ago.
Just got a rip-cut and installed my Bosch saw haven't used it yet but saw was a good fit. Got the original ripcut and didn't really like it had trouble cutting straight. New one has several improvements should make it work much better. especially…Continue
Started by William Burt Brown in General Woodworking Mar 17.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 4 Comments
© 2021 Created by KregRep.
Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service