All Discussions Tagged '6' - Kreg Owners' Community2024-03-28T08:43:06Zhttps://kregjig.ning.com/forum/topic/listForTag?tag=6&feed=yes&xn_auth=noAutoMaxx 6" clamp not workingtag:kregjig.ning.com,2021-02-12:2900167:Topic:10235342021-02-12T19:34:07.428ZAnthony M Calabresehttps://kregjig.ning.com/profile/AnthonyMCalabrese
<p>I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset the clamp and continue with a number of successive open and closing. Finally, I can close the handle with little pressure. However, this is a one shot deal and the next use goes back to a point where I cannot close the handle. In short, I cannot…</p>
<p>I have been using the Automaxx 6" clamp for two plus years, and recently the clamp is impossible to close the handles to secure the work and my jig. I cannot close the handles no matter how much pressure I can exert. I open the clamp to max to reset the clamp and continue with a number of successive open and closing. Finally, I can close the handle with little pressure. However, this is a one shot deal and the next use goes back to a point where I cannot close the handle. In short, I cannot use the clamp and have to resort to a non-Kreg clamp. </p>
<p></p>
<p>I have used the adjustment feature in both directions to no avail. Is there an issue with the spring inside the turn screw located inside the handle? Can this clamp be repaired, and if not, perhaps replaced. I am an amateur woodworker and this clamp has not been overused in any fashion.</p>
<p></p>
<p>Greatly appreciate any feedback and assistance to help remedy the problem.</p>
<p></p>
<p>Thanks in advance.</p>
<p></p>
<p>Tony</p>