Kreg Owners' Community

Goofy question. Just purchased an R3. Everything that came with it makes reference to #8 screws. Can it work for #10s also? Can't find the length of blue-kotes that I need locally in #8s, but did find #10s. Thanks! -Eryn from AZ.

Views: 1603

Reply to This

Replies to This Discussion

Eryn,

Contact KREG CS, perhaps they have recommendations.

Our screw thicknesses will scale with the length of screw. Short screws are thinner, longer screws are thicker. The more important thing to look at is the length of screw and thread type (coarse or fine). 

We suggest using the screw lengths shown below when joining materials of the same thickness.

Fine-thread screws are the preferred choice for hardwoods that are hard and dense. These threads are less aggressive, so they’ll drive without splitting, but these screws have a higher number of threads per inch to ensure great holding power.

Coarse-thread screws are recommended for use with softwoods—as well as for sheet goods such as plywood and MDF—that are soft and not very dense. Coarse screws have deep, aggressive threads that bite into those soft fibers to ensure solid holding power.

If you have any other questions, feel free to get in touch with Technical Support directly at toll-free 800-447-8638 or technicalsupport@kregtool.com

Hi again, Eryn,
Yes, the R3 will work with #10 screws. Our 2 1/2" stainless screws are this size and they work just fine. 

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_