Hi,
I just downloaded this plan. It calls for a half sheet (48"X48") piece of 3/4" oak plywood.
My problem is that I can't find a reference to it any where else in the plan.
Anyone know what's up with this?
Thanks,
Bob
Tags:
Bob,
I am unsure of the plan you are referring to. If you could let me know where you found this so I can take a look at it I would be more than happy to assist you.
Naturally, I can"t find it now. All I can tell you is that the title is "Kreg Project Plan: Multipurpose Work Center".
Thanks,
Bob
I have attached the plan.
Bob,
The drawing never specs. out for shelf's inside the cabinets. There is only specs for 2 upper 2 lower. I would have to say putting shelf pin hole inside the cabinets, would be where the other 3/4 plywood would be used.
Respectfully
Joe
Makes sense to me. Thanks.
Bob,
Sorry for the delay in responding as I was having our Marketing team look this over to double check. That piece was adding to the plan in error. We have since corrected this error and a few other we found and the new version is available for download now. If you have any other questions please let us know.
Thanks very much.
KregCS said:
Bob,
Sorry for the delay in responding as I was having our Marketing team look this over to double check. That piece was adding to the plan in error. We have since corrected this error and a few other we found and the new version is available for download now. If you have any other questions please let us know.
I can't find the plan.Can you post the URL?
KregCS said:
Bob,
Sorry for the delay in responding as I was having our Marketing team look this over to double check. That piece was adding to the plan in error. We have since corrected this error and a few other we found and the new version is available for download now. If you have any other questions please let us know.
I can't find the plan.Can you post the URL?
KregCS said:Bob,
Sorry for the delay in responding as I was having our Marketing team look this over to double check. That piece was adding to the plan in error. We have since corrected this error and a few other we found and the new version is available for download now. If you have any other questions please let us know.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service