Kreg Owners' Community

Rating:
  • Currently 0/5 stars.

Views: 381

Comment

You need to be a member of Kreg Owners' Community to add comments!

Join Kreg Owners' Community

Comment by Tito Comas on October 19, 2017 at 1:10pm

See, I am not the only one admiring your craftsmanship Andy!!

I just looked up the Essential hardware website, man they have a lot of products. Was there a category under which the legs you made were found? Did you buy the corner brackets there as well?

Tito

Comment by Andy Wilson on April 17, 2017 at 9:45am

Oh yeah - I used Weldwood Contact Cement to glue the vinyl to the box pieces before I built the box. This glue is perfect for this application. It would work on felt of canvas as well.

Comment by Andy Wilson on April 17, 2017 at 9:43am

Sure - I just kinda did it by the seat of my pants. I'll see what I can put together for you.

But just as a starter-
 The box is 25 1/2 x 110 so it would fit the wall. The bottom of the box is 1 1/2 in thick to prevent warping, etc.

 I used standard 5 1/2 width common pine to give it a rustic look.

 The inside of the box is vinyl - I pinched the ends into the box joins.
 The paying surface is stained birch plywood (1 1/2 thick) with about 8 coats of poly, I ended up making a new playing surface using no stain b/c my water-slide number decals didn't show up on the dark stain.

I got the legs from Essential Hardware . com. 

Comment by Ethan Schmidt on April 17, 2017 at 12:06am

Wondering if you are willing to share the plans for this project? Also great job I think this turned out amazing.

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_