Kreg Owners' Community

Hi Folks,

I am setting up my Beaded Face Frame system and I can't figure out how to set the cursor on the router stop. The instructions do not say how to do it. What point of reference do I use?

Appreciate any help!

Thanks!

-RM

Views: 198

Reply to This

Replies to This Discussion

Ryan,

The instructions for this application are listed on page 8 of the instruction manual for the Beaded Face Frame System.  Basically you will put the 1/2" dowel pin in your router.  Then set the cursor at the 1/4" mark and slide your fence over until the stop just touches the pin.  This will calibrate the fence along with the stop.  If you have any other questions please let us know. 

My issue was how to set the cursor on the stop itself. The plastic cursor can slide in and out. I figured it out by trial and error but the instructions do not say how to adjust the lens cursor on the stop.

Thanks!

-RM

Ryan,

Since you are setting the fence based on the position of the cursor on the tape it would not matter where this was placed as long as it was not moved once calibrated.  This is the reason that it is not covered in the manual.  I'm glad to hear that you were able to get it to work and if you need any other assistance please let us know.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_