Kreg Owners' Community

Does anyone have dimensions for an entryway bench?  I have been looking at the ones Pottery Barn sells.

Something similar to the picture below but one side only and the bench is below the storage.

Brady 5-Piece Entryway System

Views: 3097

Reply to This

Replies to This Discussion

Also know as Hall Butlers, each section can run about 28 1/2" to 30" wide but you can make them any width you need.

Here is a link to some plans that you might be able to adapt. For example, you can replace the mirror in the plans for shelving.

Jeff,

I'd suggest making dimensional plans for projects, based on the material and blank sizes you plan to cut them from.

If using plywood, layout the pieces and their respective sizes, to make the most of the sheet goods.

Allow for waist for each cut piece.

ex 12'', make your finished piece 11-3/4'', and so on.

For the bases, shown in the photo, make each a separate unit, and bank them together.

I'd make them in modular pieces, for easy transporting, at a later date.

check this link out http://kregjig.ning.com/photo/hall-tree-plans-1. It was submitted by a forum member. I also saw some free project plans  from Lowes that had a entry bench/ hall tree you might want to check out.

Looks like a nice little unit. I would guess 7 to 8 ft long and a foot or so deep. You can do some scaling from the picture and make your own plans.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_