Kreg Owners' Community

Hi Kreg community.  I just joined and have a question....

I have built my kitchen cabinets...they look great, no problems.  Now I want to build a bathroom vanity cabinet that will have two 45 degree angles.  Is there a Kreg clamp for that?  any suggestions?  

Thanks!

Views: 419

Reply to This

Replies to This Discussion

I would use the square pattern dog holes in my bench with a dog fence ( could use Kreg dogs also ) and Kreg inline clamps. Ratio to get to 45D is 1:1 so say 2 holes across and 2 holes up to place a dog and 5 holes across and 5 holes up to place the other dog. I would try a bar clamp to line the top up first and if that wasn't good enough you could make a clamping block from scrap.

You could also make 2 clamping blocks or Rockler sell an adjustable clamping square which I don't have.

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_