I'm an amateur/beginner woodworker. and just in the process of acquiring tools. I've just got the K5 and stated working with it and so far so good. I'd like to see 1/2" size screws and matching size in the sizing jig, for thinner boards. as improvement, but other then that I am very happy with it in contrary to the Multi-Mark Measuring tool. which has nice concept but unfortunately I like many others complain about the tool not being tight when measuring 90 degrees, and it has a few…
ContinueAdded by PJ on July 22, 2014 at 4:07pm — 8 Comments
I have two screw driver bits. One I got with my Kreg Jr and the head is too small for the screws. It constantly slips and rounds out the head The other I got with the K5 and it is warped. I ended up buying some replacements(not Kreg) at our local hardware store and they work perfect. Has anybody else had problems with their bits or did I just get unlucky?
Added by Bill A on July 20, 2014 at 2:54am — 5 Comments
I'm new to this community and I'm new to carpentry in general. I'm going to make a few cabinet doors and I'm planning to use the European hinges. My dilemma is there are so many brands and styles that I am clueless as to which one to buy. I realize that the decision is partially based on what the inside of the cabinet looks like so I need to make sure I buy the correct ones. I am mainly interested in the adjustable hinge because apparently you can make it perfect even if you are a tiny…
ContinueAdded by Rick Grisoli on July 5, 2014 at 4:18pm — 13 Comments
2021
2020
2019
2018
2017
2016
2015
2014
2013
2012
2011
2010
2009
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service