materials used: 2x6 and 2x4 boards, full sheet of 3/4" MDF, kreg pocket hole screws and brad nails.
tools: miter saw, Kreg pocket hole jig, Ryobi 18v drill and Ryobi brad nailer. There was some trial and error with this but eventually I successfully…
"If you double checked your stop collar setting I would venture to guess it is a case of overdriven screws. Pine will cause that because of the knots. Your preset is too high where there aren't any knots or tight grain around them & too low…"
"thanks for the reply. I am probably over driving the screws. I think I may need some practice on scrap wood to get the technique down. I will also take a look at the charts with screw choices and material. "
First off tried to mention all this to Kreg via Email and just because I live outside the USA seems that the system does not work as they say phone number invalid, which is not.OK bought a Accu-Cut and set it up no problems there worked OK both…Continue
hi all can anybody help got r3 for Xmas and I have noticed that the gray tabs are different think somebody in assembly was talking the piss day and I have 1 metric side and imperial side so they don’t match up hellllp plzericContinue
I watched the setup videos, searched for information and spent half a day and can not get the clamp to hold.i tightened up the screws underneath in various stages up to fully tightened, makes no difference.I do not get the two clicks and I can slide…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.