For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
Comment Wall (1 comment)
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community
Sandra, adding a light to your pump should be easy.
I am assuming you can do basic house-type electrical work. Not knowing the pump/switch surroundings I can only speculate what would be appropriate. An inexpensive electrical book from Home Depot or similar will show you how easy this is, and the safety practices to prevent shock.
1. You can add a neon or other small lamp to the switch housing by wiring directly to the positive out (to pump) connection and ground.
2. You could put an outlet inline with the pump, perhaps attach an electrical work box nearby and wire the pump's power line through it. Tap the outlet to the line, but do not splice it directly through the outlet or you may prevent the circuit from running unless something is plugged into it. Done properly the outlet will only be live when the pump is switched on.
Once put together you can simply plug in a lamp of any kind, or a radio or whatever will get your attention.
3. You could also use the same components used to turn on a sump pump, where the float moving below a level turns on the pump.
4. You could simply make a "flag" of some sort that gets your attention, and put it up whenever you turn on the pump. I have often done this when I had a lot of different things to do, so that I did not forget. Anything out of place that gets your attention will suffice!
Good luck with this project!
Rob