"Thanks for the reply. Even without a detailed pattern it looks good.
The 22 lb weight would be an issue if using it all the time in different locations.
I've got an 8' rolling bench that I'm planning to use for my miter saw, and…"
"Thanks all, for your interest in my design. I've used the workstation with several projects now and am very pleased with it, but unfortunately there are no plans or sketches since I assembled it more or less spontaneously, completely from…"
"Beautiful results from using pine. If I may ask a few questions...
1-What is the lumber size used? It looks like 3/4" plywood, 1x4 or 1x6's, and 4x4's?
2-Did you put a lip on the 1x lumber to fit your plywood, or just use pocket holes…"
Hi AllJust got myself a new Metabo mitre saw, kitted it out with a new Freud Pro blade as well as "pimped up" my bench with LED lighting so I can find stuff! I have 22 LED daylight tubes in my fittings in the garage so there is more than enough…Continue
I originally bought Ridgid tools for the warranty, well I had to replace batteries. Very easy and got new batteries and chargers. Found out they don't make 24 volt tools any more, so I sent in a hammer drill, impact driver and light for replacement…Continue
I am going to try and new project. Never made cabinets before. Researched and You-tubed like crazy. So many opinions. Mine are going to be:1 each= 30"W x 14"D x 38"H2 each =29"W x 14"D x 38"H1 floor to ceiling cabinet 18"W x 24"D and the height…Continue
Perhaps this question has already been asked somewhere on this forum but I wasnt able to find it after an hour or so of searching. Is there a recommended length of Kreg screw to use when combining a 1x6 into a 4x4 post. I have seen a few conversion…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.