"Yes, they are. The carbide from the Freud Quadra-cut bits leave an incredibly smooth finish. I do have a couple of Whiteside bits that also leave a very smooth cut - much better than the Skil or Bosch bits they replaced.
I still use…"
"The best router bit advice I've read is to invest in a decent lower cost router bit set when a beginner (I chose the MLCS 8377 1/2" shank 15 piece router set - which are carbide tipped), and then replace those bits that you use most -…"
"I started with the cheap assortment pack of 1/4" shanked bits from a store somewhere. Been so long I don't know where they were bought at. They will work just fine. Just take your time & make multiple passes getting to where you want…"
"My name is Diane, retired USAF. Beginner woodworker, built a small table with Kreg JIG . I like Kreg, products are good quality and easy to use. I am happy I found the Kreg Community . Eager to learn from you all. I am looking for my next beginner…"
First off tried to mention all this to Kreg via Email and just because I live outside the USA seems that the system does not work as they say phone number invalid, which is not.OK bought a Accu-Cut and set it up no problems there worked OK both…Continue
hi all can anybody help got r3 for Xmas and I have noticed that the gray tabs are different think somebody in assembly was talking the piss day and I have 1 metric side and imperial side so they don’t match up hellllp plzericContinue
I watched the setup videos, searched for information and spent half a day and can not get the clamp to hold.i tightened up the screws underneath in various stages up to fully tightened, makes no difference.I do not get the two clicks and I can slide…Continue
I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.