Comment
Dillian,
The iron pipe fixture is actual 3/8" iron pipe. What I did was use a piece of lamp all thread and I ran it through the iron pipe, flange and wood top, The lamp socket is at the top of the all thread and at the bottom a nut holds everything in place. You could also epoxy to glue the lamp socket to the iron pipe coupler at the top.
You can get the fuse from mouser or if you get an all usb outlet you don't need a fuse.
http://www.mouser.com/ProductDetail/TE-Connectivity-PB/W28-XQ1A-5/?...
I have updated plans at Steinerwoodwork.com
Paul is this the item http://www.amazon.com/Leviton-USB4P-W-4-2-Amp-4-Port-Charger/dp/B00...
Not in there list on the internet. I have amazon prime so could go that route . Haven't been in the store to check might have it there. They did have the double with single outlet.
I got my four usb block on Amazon, but since I have seen them at my home depot in Woodbridge Virginia. I bet HD will ship it to your local store for free, since they do not have it yet.
I was intrigued by your lamp design but looked at home depot site could not find the 4 usb block ?
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community