Comment
Hi David, This is my method of doing what would be an expensive molding to purchase. the thing about this is that it is fast and the molding turn out exact each time. I'm doing several hundred feet of this to trim out all of the doors in a new house. I am able to make the same molding for about 1/3 of the cost of factory molding. I looked at the cost and the quality of the molding and had a hard time finding molding that was accurately cut and even the grain colors. This way I pick and select the grain pattern as well as the color and get good results.
I have made another smaller fluting jig that I have used many times on cabinet building but needed one with a heavier build. the 1/4 trim router would not stand up to the amount of use I woudl require for this job. Since I was building it I though that maybe some of the community members might profit from seeing this.
This one can be used on any flat lumber surface up to 9 1/2 inches. I am sure you could use this on some of your fine dressers and cabinets you build. Take a look at the slide show and see what you think. If you are interesed and want more information on parts and how to build this jsut let me know.
Iwas woundering how they did that if it was done by hand or a jig.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community