Comment
Hi James, I have a choice of which to use and due to the accuracy and surface cuts that I get with the thickness planner, it is much easier to maintain an accurate surface and cut. These pieces were about 9 feet in length and on a jointer is much more difficult to maintain a constant cut without a burn or a snipe in the surface. Holding a 9 foot long board and getting an accurate cut on the surface as during the cutting on a jointer you have to stop and get a different hand placement on the board and this can lead to burning and or a snipe in the cut.
The thickness planner is so easy as it cuts with a pressure bar that keeps the stock in a steady and maintained and an even pressure down on the stock. Since the speed rate is constant and the stock held in an even pressure the cutters cut the stock smooth and accurate. It is much faster and as the stock exits the surface planner you to gently lift up on the board as it exits and clears the pressure board thus gets rid of any planner snipe on the ends. What you are seeing in this photo is the milling of one of the edges in prep for the correct size needed for the door side casing. The third step is the cutting of the flutes in the stock of which requires the stock to be absolutely true The final step is done with a router with a round nose bit held in a home made jig. Hope I answered your question.
Nice job, however, why not use a Jointer?
James
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community