Comment
Nice job hugh,wooden pens seem to be more popular here than acrylics.
Rockler offering safety glasses--- $1.99!!!
http://www.rockler.com/product.cfm?page=30160&site=ROCKLER
When turning, I ALWAYS were a face shield---ALWAYS!!!
Taken on that safety measure, since day one.
In my shop
EYE PROTECTION REQUIRED-
NO EYE PROTECTION
NO ENTRY!
It's a good practice to ALWAYS were some form of eye protection.
''The AOA, safety experts and eye doctors believe wearing proper eye protection could have lessened the severity or even prevented 90% of these eye injuries.''
(Helpful info contained herein).
http://www.aoa.org/eye-protection.xml
Most hardware stores and home centers sell eye protection, and are relatively inexpensive.
The style with a partial warp-around feature, that shields the eyes, are more readily available & popular today.
Some are available with ''bifocals''---1.5, 2.0, 2.5 and 3X magification.
Polycarbonate lens material that is light weight, impact and scratch resistant.
Thanks hugh ,plastics not too bad hugh take it slow.I did have one explode on me [needed a stiff drink after that one] for that reason hugh wear eye protection when working plastic.Look forward to the photos go steady.
Stunning work, Michael. I've just turned my first three pens this week. I've always loved the pens and it is cheap entertainment. Still working up the nerve to work with the plastics.
Thanks Ken, not the best on a lathe but only done about 40 hours on one.But if i mess up pen kits not too expensive here.
Nice collection of pens, ya got dar matie
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service
You need to be a member of Kreg Owners' Community to add comments!
Join Kreg Owners' Community