#4 Outfeed/Multi-Tasking Table

Comment

Comment by WindwoodTrader on January 19, 2010 at 12:15pm

Ted- That is about as solid as it gets!
Thanks-
John

Comment by Ted W. Broussard on January 18, 2010 at 8:49pm

BTW: the hex heads of the bolts slide into the right and left channels of the track.

Comment by Ted W. Broussard on January 18, 2010 at 8:44pm

John, here is a photo of the track attached to the table. You can see that it ain't goin' nowhere with all these bolts!

Comment by Ted W. Broussard on January 18, 2010 at 4:34pm

Thanks, Derek, I'll do that right now.
John, I will post photos and the method when I get a chance. Should be soon.

Comment by Derek on January 18, 2010 at 11:18am

BTW, TED... you should really add these photos to that link I posted above... A lof of people see that thread, that won't necessarily find their way to these photos. All you have to do is go to the thread, write a reply, and then click the little camera button to link to your existing photos. Ask if you havee any trouble. :) I love this project.

Comment by WindwoodTrader on January 18, 2010 at 11:07am

Ted-
This looks better than any I've seen! Nice job- Could you show the method you used to secure the track to the table?

Comment by Derek on January 13, 2010 at 3:20pm

A really nice setup... Have you seen the thread where everyone else posted their "Klamp" setups? Here it is: http://kregjig.ning.com/forum/topics/kreg-bench-klamp-system

A ton of great ideas there. I've built some into a set of sawhorses before... it worked well.

Comment by Ted W. Broussard on January 13, 2010 at 3:17pm

Thank you Derek. It has worked extremely well for me. Only problem is that the height was set for a Ridgid tablesaw. I now have the SawStop and will have to cut down the height to accommodate it.

Comment by Derek on January 13, 2010 at 3:15pm

Fantastic setup, Ted. What a functional table!