Tags:
Hang-in there---
stick around awhile---
I'm sure they have lots of projects in the planning stages.
Thanks, Michael, for sharing your ideas. We always love to hear what interests our Kreg fans and customers. Rest assured that we are always working on product research and development, and we are working on multiple new ideas. We always spend a lot of time during these phases to make sure that we can produce products that are innovative, functional, durable, and affordable. We'd rather spend extra time on development than rush to market with an inferior product.
Please keep your ideas coming. We are listening.
KregRep
Mike,
Temporary solution for an outfeed support:
Position an ironing board adjacent the work top---
adjust to desired height---
shim the feet to fine tune and square-it-up.
Hi Michael , this is a board that I made up for the Kreg Jig, and longer boards ! I mounted the Jig on a 40" board , then mounted an 18" section of Kreg mini t track on each side ( 36" track kms7508 cut in half ) !Also use two Kreg support/ stops for the boards to rest on, can be adjusted up to 40 " The board in the pic. is a 1 x 8" x 6' long , #2 white pine that I get at a local small town lumber yard, not the big box stores !! The jig board can be clamped to the work bench , hope this helps , JIM
James,
The photo shows the board pretty much centered---
how is the workpiece supported when its extented all the way out in either direction?
Does the clamping pressure hold the board so it doesn't fall?
james wilhelm said:
>>> Hi Michael , this is a board that I made up for the Kreg Jig, and longer boards ! I mounted the Jig on a 40" board , then mounted an 18" section of Kreg mini t track on each side ( 36" track kms7508 cut in half ) !Also use two Kreg support/ stops for the boards to rest on, can be adjusted up to 40 " The board in the pic. is a 1 x 8" x 6' long ,...../p>
Ken , yes it dose hold good , but if you use a lot of longer boards in your projects , you can get the track up to 48" long , just have to make your base board longer, this work,s for me !!!!!!
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service