Tags:
Tom,
I feel your pain.
I too experienced the same issues.
Sometimes I've had to use pliers to loosen the fitting.
Just tighten the fitting up "finger tight"---this will prevent wedging of the threads.
The threads are made from brass, and they lock-up pretty easy.
Add a dab of lith-grease to the threads, to reduce friction.
I wish they make knurls that are larger/deeper, so as to provide a better grip.
I mentioned this, some years back, but I still see no change.
On similar knurled fitting, I've enlarged the knurls, making deeper/larger grooves, using applicable machinist files.
Tom,
There could be a "metal chip", wedged in the threads, or a burr on the threads.
I contacted Kreg they are sending a new knob, hopefully this is all it will need somewhat concerned with the interface as well, I don't think I have a tap that small or know the pitch to get one, we'll see if the new knob solves the problem first, I will keep you posted. Thanks
Ken Darga said:
Tom,
There could be a "metal chip", wedged in the threads, or a burr on the threads.
I used a dremel to cut a slot in mine - and use a screwdriver. Much easier to adjust now.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
1 |
K5 Repair |
2 |
Keepsake Box |
3 |
Turned Wands |
4 |
Boxes |
5 |
Turned Pipes |
6 |
Pizza Cutters |
7 |
Bookmarks |
8 |
Coffin Shelf |
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service