Kreg Owners' Community

I have a K4 Kreg Jig Master System. With the Dust Collection Attachment in place I find it almost impossible to loosen/tighten the brass (?) knurled screw (Drill Guide Pin) that holds the Drill Guide in place at the correct height setting, and I find removing the Dust Collection Attachment for each adjustment to kind of a pain.

If Kreg was to sell a replacement Drill Guide Pin with a square drive inset added - which would allow me to use the screw drive bit to loosen/tighten the Pin - I would buy it in a heartbeat!!!

Views: 98

Reply to This

Replies to This Discussion

Ken, 

Thank you for the suggestion.  Unfortunately we do not offer a pin like you are referring to at this time.  If you are having issues with removing the pin, you can try slightly lifting up on the drill guide block as you rotate the pin relieving the weight against it.  This should make it much easier to turn allowing you to loosen it easier.  

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

1x6 into a 4x4? 1 Reply

Started by Dave N in Kreg Jig® Projects. Last reply by Ken Kortch 37 minutes ago.

Rip-Cut Ruler 4 Replies

Started by Cynthia Alaniz in Beginners' Zone. Last reply by KregCS Sep 19.

Concealed hinge jig 1 Reply

Started by Michael B in Kreg Jig® Operation. Last reply by Edward Weitsman Sep 19.

Pocket screws to attach table tops 1 Reply

Started by Joe L in General Woodworking. Last reply by Glen S Sep 4.

new member

Started by Al Baker in Beginners' Zone Aug 30.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_