Kreg Owners' Community

The last couple of times I used my k-4 jig, the pocket hole screws did not grip the wood enough to get a tight fit. It has happened more than once. any help in solving this problem. I am using select pine.

Views: 336

Reply to This

Replies to This Discussion

Just a few questions and comments: What thickness is the pine? Using coarse or fine thread screws? Are you relying on the torque setting on your drill to stop the fastening? Using glue? Here are some things to keep in mind for soft woods: use coarse screws, make sure the cut is square, and when driving the screw do not rely on the clutch setting. Put the drill on slow speed and "listen for the squeak" of the pine as the screw tightens the joint. Try it on some scrap wood. Hope this helps.

I am using  1 by boards with no glue and I have tried both coarse and  fine threads with no clutch. I tried to stop the process before it tightens so I can inch it in but at times it will strip out . Thanks for your quick response.

Russ Bransford said:

Just a few questions and comments: What thickness is the pine? Using coarse or fine thread screws? Are you relying on the torque setting on your drill to stop the fastening? Using glue? Here are some things to keep in mind for soft woods: use coarse screws, make sure the cut is square, and when driving the screw do not rely on the clutch setting. Put the drill on slow speed and "listen for the squeak" of the pine as the screw tightens the joint. Try it on some scrap wood. Hope this helps.

I'm assuming your using the correct length screws.

Grab a #2 square head screwdriver & finish by hand tightening.

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Toy box 2 Replies

Started by David J Agler in Beginners' Zone. Last reply by KregRep on Friday.

Clamp and glue thin borders 3 Replies

Started by Don Anderson in Beginners' Zone. Last reply by Ken Darga Oct 7.

routers and router stands 5 Replies

Started by tom hagan in Beginners' Zone. Last reply by R Anderson 13 hours ago.

Router guide

Started by Scott taube in Beginners' Zone Sep 26.

problem joining a table leg to the base 3 Replies

Started by Bradley Smith in Beginners' Zone. Last reply by Trace Farthing Sep 12.

Product Reviews

The Pocket Hole Joinery Book - Review

Posted by Daris R. on October 17, 2017 at 11:00pm

Kreg Mobile Project Center

I just picked up my new Kreg Mobile Project Center Item #KWS1000.

Wow!  I set it up in my basement and it is great addition to my Kreg items.  I was viewing a video where a review on this fine product was being made, which prompts…

Continue

Posted by John Tomkinson on May 5, 2017 at 5:34am — 2 Comments

© 2017   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_