Kreg Owners' Community

I currently own router table #PRS1020. I recently purchased router fence #PRS1015. The instructions for the fence state that to attach the fence to a table other than #PRS1025 I have to modify my current table. I refuse to buy another Kreg router table that automatically works with the new fence.

Has anyone had to install fence #PRS1015 on table #PRS1020? If so, what modifications did you have to make?

Views: 223

Reply to This

Replies to This Discussion

Chuck, 

The main difference between the PRS1020 and the PRS1025 is that the PRS1025 will have a key hole at the end of the slot in the table to easily allow you to remove the fence.  Without this slot you would have to completely remove the lock down handle each time you wish to remove the fence.  Also the pre-drill holes for the clamp block to attach to the table would not match up to the hole pattern for the clamp block on the PRS1015.  All you would need to do is pre-drill your own holes at the correct spacing.  

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

1x6 into a 4x4?

Started by Dave N in Kreg Jig® Projects 16 hours ago.

Rip-Cut Ruler 4 Replies

Started by Cynthia Alaniz in Beginners' Zone. Last reply by KregCS on Wednesday.

Concealed hinge jig 1 Reply

Started by Michael B in Kreg Jig® Operation. Last reply by Edward Weitsman on Wednesday.

Pocket screws to attach table tops 1 Reply

Started by Joe L in General Woodworking. Last reply by Glen S Sep 4.

new member

Started by Al Baker in Beginners' Zone Aug 30.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_