Kreg Owners' Community

Hi all,

          I'm planning my first project, the potting bench and my wife is short.

I want to make it a couple inches shorter and figure taking it off the top of the Front legs(A) and the top of the back legs(B) should do it. 

Am I missing anything???

Views: 64

Reply to This

Replies to This Discussion

Thomas,

Without knowing what set of plans you're using let me offer the following: If the back legs extend upward past the work surface height , supporting shelves, taking inches off the top of each will not work, unless you adjust the height the rear of the work surface mounts to.  If all four legs only support the work surface portion of the bench then taking an equal amount from each would work.  Another option is to take inches off the bottom of the legs and adjust the height of the bottom shelf upward by a similar amount.

Hope this makes sense, Don

Thanks Don,

                      I am using the Kreg plans for my bench if that helps anyone with my question. 

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Toy box 2 Replies

Started by David J Agler in Beginners' Zone. Last reply by KregRep on Friday.

Clamp and glue thin borders 3 Replies

Started by Don Anderson in Beginners' Zone. Last reply by Ken Darga Oct 7.

routers and router stands 5 Replies

Started by tom hagan in Beginners' Zone. Last reply by R Anderson 3 hours ago.

Router guide

Started by Scott taube in Beginners' Zone Sep 26.

problem joining a table leg to the base 3 Replies

Started by Bradley Smith in Beginners' Zone. Last reply by Trace Farthing Sep 12.

Product Reviews

Kreg Mobile Project Center

I just picked up my new Kreg Mobile Project Center Item #KWS1000.

Wow!  I set it up in my basement and it is great addition to my Kreg items.  I was viewing a video where a review on this fine product was being made, which prompts…

Continue

Posted by John Tomkinson on May 5, 2017 at 5:34am — 2 Comments

Handy jig to hold and push plugs in!

Takes 10 minutes to make this handy accessory for your Kreg gear! Home made plug pusher.

Posted by Dave Stanton on March 31, 2017 at 5:53pm — 3 Comments

© 2017   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_