Kreg Owners' Community

I am just wondering if its at all possible to use the Bench Klamps with the mini trak? in that i have two of them and was curious if anyones ever done this?

Views: 1219

Reply to This

Replies to This Discussion

I've been watching this post since 01/08/2011 for my own knowledge.

Apparently there is no answer, or, it's a top secret.  ;))

 

I just stumbled upon this post so i thought i'd check with my mini track.  No, the bench clamp will not work with the mini track for a couple reasons.

#1, because the screw in the bottom of the clamp is to large for the the mini track.

#2, i don't think the mini track would hold up under the clamping pressure.

you would need to grind the head of the screw down to fit into the track to test it

I just left woodcraft..  This may or may not help, but I bought an Incra T Track and 2 toggle clamps.  I'm going to run 1/4 bolts through the toggle clamps into a nut fitting to attach it to the T Track.  $40 worth of stuff and didn't drop a ton on the Kreg table....  Hope this helps some.

Check this photo out..
Attachments:
The bolts on the kreg clamps don't fit in the mini track. Kreg sells klamp track for the clamps. If you used t-bolts with the same thread it would work but you would have to cut them to length.

Hi Justin

 

Did you install the Inca T Track into the Kreg Router Table?

I'm trying to attach a featherboard to the Kreg Router Table and I don't have the correct hardware to get the featherboards into the Tracks on the Kreg Router Table?

Did you have this problem too?

Any suggestion?

 

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_