Kreg Owners' Community

Hi all, I just bought the K3 system and would like to build the workbench (plans available for download on the Kreg website). For some unknown reason, my computer will not allow me to download those plans.

 

Does anyone have a copy (pdf) of the simple workbench plans available to email to me???? Any help would be greatly appreciated as it's kind of difficult to use my new toy without a place to use it.  :-(

Views: 3234

Reply to This

Replies to This Discussion

THANK YOU very much James!!
I saw the YouTube video on the workbench. The presenter mentioned that in the USA 4 x 2 is only 1.5 inches thick. That seems a lot undersized for planed timber.

We have to use metric over here, (At least to buy) but our sawn '4x2s' are a full 100mm x 50mm, and are about 3mm undersized when planed.

Pre-metric, that equated to 3-7/8* x 1-7/8" in 'old money'. 3.5" x 1.5" seems to be a mite skinny for a workbench. Any comments folks?
Regards
John (UK)
Thanks for that Robert.

I think I shall beef up to 50mm thickness. The 30mm is less than 1.25" and I feel it's too flimsy in comparison to 1.5". Now, I am going to surf for some round-shank Kreg-drills, and stock up!

Thanks again.
John
I though about it when built my first bench and was going to take a 2 x 6 and cutting it to 3.5 x 1.5. Reason being the corners are rounded off on 2 inch demension lumber.
But I wanted to see if you could get good joint with Kreg Jig. Joint was good. When I build another I will rip 2 x 6 to 1.5 X 5 and adjust demensions to plans I'll get better joint.

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Cabinet Hardware Jig - Brad Point Bit vs. Regular Twist Bit 1 Reply

Started by Ken Kortch in Other Kreg® Products. Last reply by Brad Martin yesterday.

What hinge should I use? 2 Replies

Started by Lynn Greff in General Woodworking. Last reply by Lynn Greff yesterday.

Kreg cabinet hardware jig

Started by Robert Melrose in Other Kreg® Products Apr 16.

designing your projects on-line 4 Replies

Started by Robert Wolf in Beginners' Zone. Last reply by KregRep on Thursday.

Plugs For 2x4's 4 Replies

Started by Dan Smith in Beginners' Zone. Last reply by Glen S Apr 9.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 1 Comment

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_