Kreg Owners' Community

I bought a Toolboxx for my dad for Christmas (and got one for myself while I was at it) and sadly, by the time my dads' showed up, his handle was broken. I think it's one of the plastic end pieces that's at fault.

Any idea if there's another brand that might have similar-enough parts to swap some on, or does Kreg stock replacement parts for these? He lives just down the road in Des Moines so stopping by to pick up a part wouldn't be out of the question. I'd send him the part off my own boxx, but then we have the same problem again, just relocated to Virginia.

Thoughts? I know these were limited, and he's being a trouper and keeps saying he'll just use it as it is anyway, but I hate the thought of it working at less than optimal, you know?

Views: 793

Reply to This

Replies to This Discussion

I forgot to mention that UPS appears to be standing behind the damage, but we're still out a fully-functioning Toolboxx.

I bet Kreg will ship a new one if not that is poor PR

Kreg contacted me privately and has definitely exceeded any expectation I had. They have taken care of the issue and made my Dad and me both very, very happy. I didn't post this expecting the company themselves to take the issue on directly but I am pleased that they chose to do so.


Jens Jensen said:

I bet Kreg will ship a new one if not that is poor PR

Not sure if this helps, I purchased a similar design box from Sears.... check out those dimensions may work. Good Luck

I have dealt with customer relations at Kreg, and found them to be quite responsive to my needs and would very helpful in replacing the part that was defective.  They are a reputable company, and I am sure that you will receive satisfaction.  

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_