Kreg Owners' Community

I was in the process of drilling pocket holes in a gaggle of milled 2 x 4s and 3/4 ply  to build a cart for my lathe.  In the process, I knocked my drill off the bench with my Kreg bit in it.  When I went to drill the next holes, I discovered that I had bent the bit where the hex shaft meets the drill rod.  My question is can this be repaired by the sharpening service, or should I trash it an get another?  

Fortunately, I purchased a spare bit some time ago, and was able to finish drilling the pocket holes.  The ease at which the new bit worked also indicated to me how dull the old, now bent bit had become.

Views: 269

Reply to This

Replies to This Discussion

If it is bent I would say scrap it and get a new one just to be safe.

Tim,

Check with your sharpening service, if they can accomplish this task.

Check with a tool-machine shop, in your area.

(Most don't possess the skill to perform this task.  They may be fearful of breaking the drill bit).

Bent drill bits can be straightened/made "true",

with adequate techniques.

I've encountered bent drill bits, and fixed them to "run true".

Tim, 

If you contact our Technical Support team at 1-800-447-8638 or technicalsupport@kregtool.com, we would be more than happy to assist you with this situation.  

I contacted T.S.  Josh was great, thanks!

Reply to Discussion

RSS

Need Help?

Technical Support is happy to help via phone or email. Call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Product Reviews

Laguna 14BX Band Saw

Posted by Tim Grace on December 20, 2016 at 1:52am — 1 Comment

Kreg mobile project center

Posted by Gary roofner on November 21, 2016 at 10:00am — 8 Comments

© 2017   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_