Kreg Owners' Community

Which screws are best for joining two 5/4 pine boards, 90degree in this case,
Then best screws for 5/4 board to 2 x4's
I have both HD jig and standard K5

Views: 176

Reply to This

Replies to This Discussion

1.  >>>joining two 5/4 pine boards/span>

2" screws

jig setting 1-1/4" mark

2. >>>5/4 board to 2 x4's/span>

2" screws

jig setting 1-1/4" mark

Use your K5 jig

The HD jig is intended for stock material 1-1/2" and thicker.

Reply to Discussion


Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 


  • Add Videos
  • View All


Is my drill speed set too high when screwing?

Started by Matthew Hinton in Beginners' Zone 6 hours ago.

Solid wood plugs too short? 2 Replies

Started by Doc JL in Other Kreg® Products. Last reply by KregCS Jan 15.

Euro hinges jig question 9 Replies

Started by Laura in Beginners' Zone. Last reply by Laura Jan 6.

Tapered Table Legs 6 Replies

Started by Pamela Anders in Beginners' Zone. Last reply by Anthony Saba Jan 12.

New here... 7 Replies

Started by Jack Julius in Beginners' Zone. Last reply by KregRep Dec 18, 2017.

Product Reviews

Kreg Foreman

I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.



Posted by justin waldron on January 8, 2018 at 4:05am — 2 Comments

Kreg K5 Jig Review

Posted by Daris R. on November 20, 2017 at 5:39pm

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service