Kreg Owners' Community

I have almost completed construction of the Shop Vacuum Cart (I have attached a link to the plans which are available on the Kreg website. Shop%20Vacuum%20Cart%20with%20Built%20In%20Storage.pdf) I am very impressed with how the cart is proceeding. I am convinced it is going to be a big asset to my shop and, at my age (69), an asset to my back.

I have decided to build a second cart to carry my air compressor. I have attached a photograph of the compressor.

I do have a question and need input. There is a relief valve on the front of the compressor. I have included a photograph which shows the location of the valve. As you can see, when opened the valve evacuates the high pressure air in the tank downward. Since I live in Corpus Christi, located on the Gulf Coast, the air always has a significant amount of moisture. This means if the compressor were sitting on the cart the relief valve, when opened, would blow high pressure air and water downward onto the plywood bottom of the cart. I am concerned that over time this would lead to degradation of the plywood.

The workaround I have come up with is to use a hole saw to cut an opening below the relief valve. Do you believe this would be an adequate workaround? If not, do you have a better idea?

Views: 197

Reply to This

Replies to This Discussion

I think your idea would work, but to keep the plywood away from moisture, how about drilling a 2" hole for the relief valve and installing a 2" PVC ring that would protect the plywood?

And an elbow to push the air back under the cart to keep from blowing floor dust in your face.

On my larger compressor, I attached a line to the drain valve to route the moisture out of the shop.  I had to change out the valve (I went to a 90° throw ball valve instead of one that I had to turn a million times to fully open) to affix the line.  You can route the line to any exit point you want, even relocate the valve to make it easier to access. 

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Missing clamping table project 3 Replies

Started by Brandon B. in Beginners' Zone. Last reply by jock sloan on Tuesday.

90 gallon aquarium stand

Started by Glenn Gilbert in Community-Specific Jun 11.

Proper clamping technique 1 Reply

Started by Ron Salgado in Kreg Jig® Operation. Last reply by KregRep May 31.

Edge joining 3/4 inch plywood 2 Replies

Started by Lynn Greff in Beginners' Zone. Last reply by Lynn Greff May 20.

Where can I get a K3 owners manual.... 3 Replies

Started by John Chasse in Beginners' Zone. Last reply by John Chasse May 19.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_