Kreg Owners' Community

I have asked for information on making flat panel(slab door) cabinets for a laundry room and an add-on room for my kitchen.  I only seem to get information on raised panel.  I really need some good directions, especially on how to make the doors so they do not warp and even a good easy free woodworkers calculator for figuring out material to make them.  Any help would be hugely appreciated.  Thanks!

Views: 1029

Reply to This

Replies to This Discussion

Sorry if I sounded condescending. That was not my intent. All I was trying to do was give suggestions to help someone with a technique that I found to help with slab doors.

Good day.

I appreciate it.  I am just new to all this and don't understand everything.  Including what things are called at times.  Then with all the information and ways to do things, I get overwhelmed.  Your cabinets are beautiful.  I hope mine turn out respectable, otherwise I see a lot of wood making it into the fireplace before I get it right.  I almost want to buy some junk wood to practice with.  It would be my luck that it would turn out amazing...then what do I do with it.  :)  I do appreciate your information.  Steph

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_