I would like to build a display case to showcase medals & awards my father recieved in WW2, along with the flag used at his burial. Does any-one know of plans available for this?
Tags:
Hi Walter - There are a ton of flag display case plans available on the internet, just google "flag display case plans". Here's one:
johnpadgett.com/4866/johnpadgett.com/woodworking/FlagCase.pdf
That one is just for the flag, you can expand the base down to a rectangular box for the medal display. Note that flag display cases are not equilateral triangles, instead they have a 45-90-45° layout.
John Schaben said:
Hi Walter - There are a ton of flag display case plans available on the internet, just google "flag display case plans". Here's one:
johnpadgett.com/4866/johnpadgett.com/woodworking/FlagCase.pdf
That one is just for the flag, you can expand the base down to a rectangular box for the medal display. Note that flag display cases are not equilateral triangles, instead they have a 45-90-45° layout.
Thanks John. I overlooked the obvious by not using Google. There were quite a few good ideas there.
Thanks again............Walt.
Walter Frimberger said:
John Schaben said:Hi Walter - There are a ton of flag display case plans available on the internet, just google "flag display case plans". Here's one:
johnpadgett.com/4866/johnpadgett.com/woodworking/FlagCase.pdf
That one is just for the flag, you can expand the base down to a rectangular box for the medal display. Note that flag display cases are not equilateral triangles, instead they have a 45-90-45° layout.
For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST.
I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters. What setting on the Jig should I used? 1 ½ is too much. Thanks.Continue
Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.
Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue
Started by Ed Anderson in Beginners' Zone Oct 3, 2023.
I saw the video Kreg put out for this new jig and had high hopes for it.
I purchased one today and am very disappointed with it.
First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…
ContinuePosted by Duke Leon on February 15, 2021 at 9:00pm
Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction. I have considerable experience with conventional…
ContinuePosted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments
© 2024 Created by KregRep. Powered by
Badges | Report an Issue | Privacy Policy | Terms of Service