Kreg Owners' Community

I recently purchased the Crown Pro jig. In the instructions it mentions to set the mitre saw table depending on if 0 or 90 is in the middle of the table. My saw has 45 in the middle. How do I figure how to set the angle?

Views: 239

Reply to This

Replies to This Discussion

I think they mean to say "when your saw is set to make a square cut to the fence, what is the pointer pointing to?"  There, the answer to the question would be either 0 or 90 degrees.  Most saws will point to 0.

Some saws made by Bosch, Craftsman and Wen (and others) have the pointer and scale offset so directly in front of the saw is the 45 degree mark.  When the saw is set to make a square cut, the pointer will point at 0 degrees.

Tim, thank you for your good advice, Kevin, if you would like any further information, please contact our Technical Support Team directly at 800-447-8638 or technicalsupport@kregtool.com

I made my own jig out of some scrap wood. I apologize for the video not being the best but it will show you the basics of what you need to do.

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

LED Lighting on mobile bench

Started by Steven Baynes in Miscellaneous Oct 8.

Ridgid tools 1 Reply

Started by steve kidd in Beginners' Zone. Last reply by Glen S Oct 9.

Cabinets and the best wood choice for the carcass. 3 Replies

Started by Stephanie H in Kreg Jig® Projects. Last reply by Glen S Oct 2.

1x6 into a 4x4? 4 Replies

Started by Dave N in Kreg Jig® Projects. Last reply by Edward Weitsman Sep 29.

Rip-Cut Ruler 5 Replies

Started by Cynthia Alaniz in Beginners' Zone. Last reply by Glen S Oct 2.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

Kreg Foreman

I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.

The…

Continue

Posted by justin waldron on January 8, 2018 at 4:05am — 2 Comments

Kreg K5 Jig Review

Posted by Daris R. on November 20, 2017 at 5:39pm

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_