Kreg Owners' Community

Hello,

I own a Dewalt track saw and am wondering if it can fit on the Kreg Rip-Cut guide.

I’m looking for way to make repetitive cuts with the track saw (without investing lots of money).

Anyone ever tried this?

Thanks for your feedback
Kain

Views: 1925

Reply to This

Replies to This Discussion

Hi Kain-

The Accu-Cut is designed for use with circular saws. You can mount almost any circular saw - left or right blade - the Universal Sled. 

Most corded and cordless saws with blades from 6" to 7-1/4" are compatible. The blade can be on the left or right side. Some cordless saws with small blades (4" diameter and under) can be challenging to fit. The saw shoe (base) can be cast or stamped metal. We recommend staying away from saws with plastic blade-guard housings. Worm-drive saws will not work with the Accu-Cut.

If you have any further questions, feel free to contact Technical Support at toll-free 800-447-8638 or technicalsupport@kregtool.com

Hi Dave,

I like the way you think!   I'm always trying to find easier ways to save steps on repetitive tasks.

I don't think what you're describing here would work though.   If I'm reading you correctly, you want to keep your track on your Dewalt track saw AND attatch the Rip-Cut to that?

The circ saw sits on a little sled that attaches it to the Rip-Cut and when you use it you push the saw and that pushes the sled forward.  You would have to rig up some way to attach the Rip-Cut to your Dewalt over top of the existing Dewalt track to use them together.

Wouldn't it be easier to just cut a couple of pieces of plywood scrap to use as spacers and clamp them along the edge of the sheet you were cutting, then set the track up against the spacers? 

Cheers,

Dan

Reply to Discussion

RSS

Need Help?

For Technical Support, please call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm CST. 

Videos

  • Add Videos
  • View All

Forum

Jig settings for 2 ¾ x 1 ½ boards with 30 degree miters?

I making a hex ring out of 2x4s ripped to 2 ¾ inches wide with 30 degree miters.  What setting on the Jig should I used? 1 ½ is too much.  Thanks.Continue

Started by Patrick Halinski in Kreg Jig® Operation Dec 30, 2023.

40mm Cup Hinge Jig Question

Hi All.....I have the 35mm Kreg Jig hinge drill guide. The guide is great for 35mm Hinge Cups, but I have a speciality 40MM hinge cup to drill.Has anyone adapted the Kreg guide to work with 40mm Forsner drill bits? Or have a guide that works…Continue

Started by Ed Anderson in Beginners' Zone Oct 3, 2023.

Product Reviews

New Kreg 720Pro

I saw the video Kreg put out for this new jig and had high hopes for it.

I purchased one today and am very disappointed with it.

First the docking station is extremely cheap. The plastic is pathetic. A Lego has more…

Continue

Posted by Duke Leon on February 15, 2021 at 9:00pm

Not Pleased With Pocket Hole Construction

Several months ago, I purchased the Kreg K4MS so that I could build the Lego Table as outlined on the companion "buildsomething" web site which exclusively uses pocket hole construction.  I have considerable experience with conventional…

Continue

Posted by Robert Ringel on September 17, 2020 at 1:48pm — 9 Comments

© 2024   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_