Kreg Owners' Community

Angles less than 90 degrees - where to drill the pocket hole

Hey all,

New to Kreg system, but not new to DIY stuff.  Just bought a K5 system and added an HD jig as well.  I'm attempting to build an awning that will have a 30 degree sloped roof.  There will be a 2x4 against the wall, a 2x4 at the 30 degrees and a 2x4 joining the two together with one end cut at 60 degrees and then a straight 2x4 joining that structure to an identical one on the other side.  The 90 and 180 degree joints, no issue, but not sure how to do the 30 and 60 degree joints.  Think of the "P" in Def Leppard for a representation of each side structure.   Thanks in advance.

Views: 372

Reply to This

Replies to This Discussion

Marcus,

I'd make test sample pieces.

Think of two such short sections, cut the desired angle, bring the joints together, 

place the intended screw on top the sample test pieces,

and mark with a pencil where the pocket holes will be located.

The pocket hole location will be determined by the length of the screw---

The longer screw near the heel of the joint, and a shorter screw nearer the toe end of the mitered cut.

OPTION

make a pattern out of a section of cardboard stock, and place the screws on the pattern, so as to determine where the screws are to located, to achieve the strongest joint section.

i.e., the pattern to be 3.50" wide, as like that of a 2x4 is is actual 3.5" side.

NOTE:  the further apart your screws are in the jointed mitered members, will result in a stronger joint.

A longer screw will result in deeper engagement into the joining member.

 

Thanks Ken.  I assume the heel is the "thick" part of the joint and the toe is the "thin" part of the joint?

The pointed end is the "TOE"

The opp end is the "HEEL"

Thanks!

Ken Darga said:

The pointed end is the "TOE"

The opp end is the "HEEL"

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

mitered shadow box 1 Reply

Started by Lloyd V. Robichaux, Jr. in Beginners' Zone. Last reply by KregRep yesterday.

Can deck jig fastening limit heat expansion? 1 Reply

Started by Glenn Scott in Beginners' Zone. Last reply by Brad Martin on Monday.

Clamp assemblyr 1 Reply

Started by Vince in Beginners' Zone. Last reply by KregRep Jul 9.

Holding 2 pieces together 1 Reply

Started by Scott in Beginners' Zone. Last reply by Tim Grace Jul 11.

Cabinet hardware jig knurled nuts loose

Started by Jeff Thomas in Beginners' Zone Jul 5.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_