Kreg Owners' Community

Hi There fellow pocket holers,

I am working with 1 3/8" (35mm) hardwood (oak) stock.

The Kreg Owners Manual says (or rather implies) that I should be using fine thread screws at 2" (51mm)  length.

Problem is I cannot find these to buy anywhere.

So I am wondering -

Does Kreg make them in the first instance?

If not

What might be a suitable alternative?

Response from Kreg directly would be appreciated also.

Regards

Novice

Views: 107

Reply to This

Replies to This Discussion

I came across this on-line response from Kreg:

https://www.kregtool.com/customer-service/questions/joining-tools-q...

"Why is there not a fine-thread screw longer than 1-1/2"?

We do not offer a fine-thread screw longer than 11/2" due to the fact that fine-thread screws have a smaller diameter and have the tendency to break off in harder woods. If you are working with hardwoods thicker than 11/2", you can set your jig up for 3/4" and use the 11/2" fine-thread screw. This will give you almost 1" into the mating piece, creating a strong joint."

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Missing clamping table project 3 Replies

Started by Brandon B. in Beginners' Zone. Last reply by jock sloan yesterday.

90 gallon aquarium stand

Started by Glenn Gilbert in Community-Specific Jun 11.

Proper clamping technique 1 Reply

Started by Ron Salgado in Kreg Jig® Operation. Last reply by KregRep May 31.

Edge joining 3/4 inch plywood 2 Replies

Started by Lynn Greff in Beginners' Zone. Last reply by Lynn Greff May 20.

Where can I get a K3 owners manual.... 3 Replies

Started by John Chasse in Beginners' Zone. Last reply by John Chasse May 19.

Product Reviews

Kreg Project Center Work Station

The Kreg Project Center is great by itself, but 2 KPC's are better than 1 when you want to set up a 12 ft. work station in a couple minutes.…

Continue

Posted by Glenn Revheim on April 5, 2018 at 5:57am — 4 Comments

Festool Domino 500

The first thing I will do is set price aside and focus on the tool and why I bought the Domino. 

      I have orders for a few dining tables and chairs.  I have made one prototype chair, while I have all the tools to make angled…

Continue

Posted by justin waldron on April 2, 2018 at 5:46am

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_