Kreg Owners' Community

Wondering about making a panel of 1x4s screwed together side to side. What length screw is needed? I have 1 1/4" but worried about being too long. Thanks!

Views: 520

Reply to This

Replies to This Discussion

Mike,

1-1/4'' is the suggested screw to use in 1x stock (measures 3/4'' thick).

Course thread for soft woods, and

fine thread for hardwoods.

NOTE:  make practice piece assemblies before proceeding to your final project. 

Make sure you use some glue too. It will make a better panel.

I would use pine boards they flush nicely

Reply to Discussion

RSS

Need Help?

For Technical Support, call 800-447-8638 or send a message. Reps are available Monday through Friday from 8am to 5pm (CST). 

Videos

  • Add Videos
  • View All

Forum

Pneumatic conversion pocket hole

Started by Michael B in Beginners' Zone on Tuesday.

Kreg Storage 2 Replies

Started by Jim Mahan in Kreg Jig® Projects. Last reply by R. E. Woods on Friday.

Old Kreg Jig - K1?

Started by Kent Bruner in Kreg Jig® Purchasing Feb 11.

concealed hinge jig stop collar 1 Reply

Started by Joe Grane in Other Kreg® Products. Last reply by KregRep Feb 12.

Kreg Jig K3 defect or not? 5 Replies

Started by Igor in Kreg Jig® Purchasing. Last reply by Randy Hills on Tuesday.

Product Reviews

Kreg Foreman

I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc., it seemed like a smart choice.

The…

Continue

Posted by justin waldron on January 8, 2018 at 4:05am — 2 Comments

Kreg K5 Jig Review

Posted by Daris R. on November 20, 2017 at 5:39pm

© 2018   Created by KregRep.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_