Kreg Owners' Community

Ken Darga's Discussions (1,707)

Discussions Replied To (1693) Replies Latest Activity

"Lee, Yes, the mini works for me. I started with the mini, for making repairs and rei…"

Ken Darga replied 1 hour ago to Drill Guide Block Question

12 1 hour ago
Reply by Lee C McLaughlin

"Lee,  Use the search field, located in the upper right hand corner of this page--- v…"

Ken Darga replied 6 hours ago to Drill Guide Block Question

12 1 hour ago
Reply by Lee C McLaughlin

"The MKJKIT mini jig kit is very useful for small tasks, such as small builds, drilli…"

Ken Darga replied 7 hours ago to Drill Guide Block Question

12 1 hour ago
Reply by Lee C McLaughlin

"Zint, The far end, where the drill bit enters to make the pocket hole, is about 2-1/…"

Ken Darga replied on Wednesday to Wood Width

7 yesterday
Reply by Lee C McLaughlin

"Dave, When attempting joinery methods, that one is not familiar with, it's a good pr…"

Ken Darga replied on Tuesday to Mitered Corners

6 on Tuesday
Reply by Ken Darga

"Dave,  If I understand what you're trying to accomplish--- a. 45 mitered corners, wi…"

Ken Darga replied on Sunday to Mitered Corners

6 on Tuesday
Reply by Ken Darga

"The "Hi-Low" fastener is the minimal performance solution for fastening in low press…"

Ken Darga replied Oct 23 to Screw Thread Selection

2 Oct 23
Reply by Ken Darga

"Bring the drill to full speed, before you start the boring. When you touch the wood,…"

Ken Darga replied Oct 21 to Clean Drilled Holes

3 Oct 23
Reply by Jerry Morris

"Thanks Mick. Doing okay. Just busier than a one legged cat in a sand box. "

Ken Darga replied Oct 12 to Shop cold weather storage?

8 Oct 13
Reply by Rita B.

"Rita, Winter Storage Iron materials, such as on table saws, drill press, planers, a…"

Ken Darga replied Oct 12 to Shop cold weather storage?

8 Oct 13
Reply by Rita B.

RSS

Need Help?

Call 800-447-8638,
or contact us online.

Product Reviews

Kreg Jig HD

Posted by Rod Darmody on September 9, 2014 at 11:00am

Right Angle Clamp

Posted by José Ochoa on September 3, 2014 at 7:22pm

Kreg Right-Angle Clamp - Improvement suggestion...

Posted by PJ on August 31, 2014 at 5:58pm

© 2014   Created by KregRep.

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

_